Re: Migrate OA & Blade iLO interfaces to new VLAN

Hi
All below steps are correct, While doing this active the VC module (Flex10) may experience NO-Communication (May not communicate to OA) in that case it will impact the production network traffic. Hence for safer side please schedule maintenance windows to perform this action.
1) Configure new VLAN on switches and identify ports used for the OAs.
2) Log on to OAs and change IP addressing to new IPs associated with the new VLAN. At this point I lose connectivity (I'll be doing this remotely).
3) Change the switch ports that connect to each OA to be access ports in new VLAN. At this point I should regain access to the OAs on the new OA IP addresses.
4) Change the blade iLO IP addressing to the new VLAN.
5) Change the Flex10 IP addressing to the new VLAN.