As a followup from yesterday, I finally was able to flash the VC module and was eventually able to login to the web gui. Hopefully this will help someone migrating off OneView.
What was required, was an upgrade of my local install of VCSU to version 1.15.0 (Aug 2019) on Linux. I ran the update command, and provided the chassis and OA login credentials, and pointed VCSU to upload the vcfwall480.bin firmware image downloaded from HP. Success! Firmware has been flashed from 4.62 to 4.80. This process took about 10 minutes.
Following that, I went back to OA, clicked the link to Virtual Connect Manager, and I was able to login immediately and complete the setup wizard without issue.
Hope this helps!
↧
Re: Migrate back to VCM from OneView
↧