Quantcast
Channel: All BladeSystem - General posts
Viewing all articles
Browse latest Browse all 1655

Can't set ip address for interconnected bays

$
0
0

We are using BladeSystem c7000 D firmware 4.85 Apr 06 2018

I've notice all of our interconnect bays for our blade switches have the same managment IP address therefore we cannot connect to the management console.

Screenshot 2019-02-23 at 11.38.44.png

I've tried unticking enabled and powering on/off each bay. Which then sets them to 0.0.0.0. Then have given them new ip addresses and resest each one at a time and only enabled one bay at a time. 

Screenshot 2019-02-23 at 10.14.22.png

once I enable bay 3 it sets all the ip's to bay 3's address.

Screenshot 2019-02-23 at 09.16.53.png

(bay 4 also changed to 192.168.8.133, I didn't get a screenshot)

I've also tried via cli......

dev-ilo-01> show interconnect list                              

Bay Interconnect Type     Manufacturer      Power   Health   UID  Management IP
--- ----------------- -------------------- ------- --------- --- ---------------
  1 Ethernet          Cisco Systems, Inc.  On      OK        Off 192.168.8.203  
  2 Ethernet          Cisco Systems, Inc.  On      OK        Off 192.168.8.203  
  3 Ethernet          Cisco Systems, Inc.  On      OK        Off 192.168.8.203  
  4 Ethernet          Cisco Systems, Inc.  On      OK        Off 192.168.8.203  
  5 [Absent]          
  6 [Absent]          
  7 [Absent]          
  8 [Absent]          
Totals: 4 interconnect modules installed, 4 powered on.
dev-ilo-01> SET EBIPA INTERCONNECT 192.168.8.201 255.255.255.0 1

Entering anything other than 'YES' will result in the command not executing.

It may take each interconnect several minutes to acquire the new settings.

Are you sure you want to change the IP address for the specified
interconnect bays? YES


Successfully set 255.255.255.0 as the netmask for interconnect bays.
Successfully set interconnect bay # 1 to IP address 192.168.8.201

For the IP addresses to be assigned EBIPA must be enabled.

then i check again:

dev-ilo-01> show interconnect list                              

Bay Interconnect Type     Manufacturer      Power   Health   UID  Management IP
--- ----------------- -------------------- ------- --------- --- ---------------
  1 Ethernet          Cisco Systems, Inc.  On      OK        Off 192.168.8.203  
  2 Ethernet          Cisco Systems, Inc.  On      OK        Off 192.168.8.203  
  3 Ethernet          Cisco Systems, Inc.  On      OK        Off 192.168.8.203  
  4 Ethernet          Cisco Systems, Inc.  On      OK        Off 192.168.8.203  
  5 [Absent]          
  6 [Absent]          
  7 [Absent]          
  8 [Absent]          
Totals: 4 interconnect modules installed, 4 powered on.

 

 


Viewing all articles
Browse latest Browse all 1655


<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>